3d_printing
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
3d_printing [2026/03/04 13:02] neil [How much does it cost to print?] |
3d_printing [2026/08/26 16:11] (current) neil |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== 3D Printing ====== | ====== 3D Printing ====== | ||
| - | We have three 3D printers in the venue all located in the [[Hack space]] in the [[PC Room]]: | + | We have a [[Creality K1C]] 3D printer in the [[Hack space]] in the [[PC Room]]. It's the red enclosed glass printer on the shelves on the back wall. |
| - | * [[Creality K1C]] - this is the red enclosed glass printer. | + | |
| - | * Qidi Smart X3 - this is the white enclosed plastic printer, it's only been used once, but seems to have a clog in the extruder. It needs opened up and any PLA ejected before it will work again. | + | Most PCs in the club have Creality Print installed and set to print to the IP of the printer (192.168.1.17). |
| - | * Creality Ender Pro v3 - this is the open (not enclosed) printer. It works, but is having a problem feeding/extruding filament. I've ordered a replacement extruder which should arrive around the 12th of June. | + | |
| Current filament stocks (in the shelf above the printers): | Current filament stocks (in the shelf above the printers): | ||
| Line 21: | Line 20: | ||
| |Wear and tear (significant maintenance every 1,500 hours) [£200]| £0.066| 6.6p| | |Wear and tear (significant maintenance every 1,500 hours) [£200]| £0.066| 6.6p| | ||
| ^Cost per 10 gram^ £0.22^ 22.0p^ | ^Cost per 10 gram^ £0.22^ 22.0p^ | ||
| + | |||
| + | |||
| + | ==== Old Printers ==== | ||
| + | We had the following other printers but gave them away as the K1C is much easier to use. | ||
| + | * Qidi Smart X3 - this is the white enclosed plastic printer, it's only been used once, but seems to have a clog in the extruder. It needs opened up and any PLA ejected before it will work again. | ||
| + | * Creality Ender Pro v3 - this is the open (not enclosed) printer. It works, but is having a problem feeding/extruding filament. I've ordered a replacement extruder which should arrive around the 12th of June. | ||
3d_printing.txt · Last modified: 2026/08/26 16:11 by neil
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
